SUZUKI KATANA 600

The Right Suzuki OEM Part for Your Bike Whether you ride your Suzuki motorcycle for leisure, use it to go off-roading, as a dirt bike or you commute on your bike, you know first hand the importance of maintenance. If you are like most sport bike owners, you meticulously clean it every weekend, which includes removing the chain and lubricating it, checking your fluids and topping them off if necessary. For most motorcycle owners, this is where our job ends and the mechanic's insight is needed when more complicated work is needed.

KAWASAKI ZX6R

These sliders have been designed to offer unsurpassed protection to your 2005
Kawasaki ZX6R 636 Ninja in the unfortunate event of a lowside or tip over.
Motovation frame sliders are designed and manufactured by a company that only
makes frame sliders. Each and every model is tested for drop and slide protection.
They are tough but not brittle and can also absorb a huge impact. Sportsriders
around the world who have tested various models of our products on the track have
all given their thumbs up after experiencing first hand, the benefits of Motovation
Frame Sliders.

Please read all instructions before beginning work! These frame sliders are designed
to fit specific engine mounts of your 2005 Kawasaki ZX6R 636 Ninja. This kit
has separate left and right pieces (left and right while sitting on the bike). It is
highly recommended that you refer to your service manual before performing this
installation. Some fairing modification is required on the left side.

Included in this frame slider kit:

(1) 10mmX90mm 1.25 pitch bolt (left)

(1) 10mmX130mm 1.25 pitch bolt (right)

(2) Aluminum bushings (pressed into slider)

(2) Plastic Frame Sliders (left -longer, right-shorter)

INSTRUCTIONS:

Left Hand Side ( Sitting On Bike )

Remove left side fairing.

Remove( See picture ) correct engine bolt and save the nut.

Replace with the provided left frame slider ( Longer Aluminum Spacer) and 100mm
bolt
and re-use the stock nut.

Tighten the frame slider to the manufacturer's recommended torque settings.

Replace the fairing and mark the edge of the fairing that needs modification. Tape
fairing over with masking tape and dremel the fairing till it just clears the frame
slider.
Reinstall fairing.

Right Hand Side ( Sitting On Bike )

Remove ( See picture ) correct engine bolt and save the nut.

Install the provided right frame slider ( Shorter Aluminum spacer ) and 130mm bolt
and
re-use nut.

Tighten the frame slider to the manufacturer's recommended torque settings.

DO NOT OVERTIGHTEN.